JTAG Kit #2:XB360-MC34

Spare part for Team Xecuter product

JTAG Kit #5:XB360-MC30

Spare part for Team Xecuter product

JTAG Kit #8:XB360-MC31

NAND-X QSB PCB KIT:XB360-MC32

NAND-X Pin Headers:XB360-MC33

Spare part for Team Xecuter product

LT Switch V2 + LT Clip:XB360-MC35

This kit has been designed with the beginner in mind. It’s been in development for a while due to the absolute precision and stability needed to make sure it works for the the lifetime of the DVD Drive with no soldering or glue for trace repairs. We have even included a built in continuity tester to make sure your trace cuts are perfect.

Cygnos V2.0 revision F:XB360-MC36

Quicksolder Module Kit for Nandflasher:

The full kit (with 3 modules, A, B and C) for Maximus Nandflasher.

This quicksolder kit makes the nandflasher installation a breeze, its recomended you leave the kit installed on the console so you can in the future do a restore or recovery from a brick, etc.

This is a set of quicksolder boards same to those who came with your nandflasher

Xecuter 2.6 CE for xbox360

This simple device will put you at ease for those hard to do 83850c v2 and 93450 Lite-On Drives.
It is recommended that if you use iXtreme LT you do a 100% dump of all Lite-On drives, provided they are stock. 
This is due to the Laser Calibration checks.

VAMPIRE:

This device will help to professional installers to do the Firmware reading on the latest Liteon drives (83850V2 & 93450). Its based on the MRA concept and 100% compatible with all Xtractor units, it connects directly on the Xtractor pin port. It came with 2 visual indicators, one for polarity check and other for Vendor Mode.

LT Switch for XBOX 360:

Liteon Kit (CK3 Probe + LT Switch) for xbox360
The ultimate kit from Team Xecuter for Liteon drives, it will do ALL version.

LT Switch:

The latest version of Xecuter LT Switch, with new updated features:

* Redesigned circuit to give a cleaner filter when switching to Vendor mode. No more read errors !

Magic Mushroom Mod M3

Maximus 79 Passkey incl:

Just install the device and do the flashing as if it was a previous Hitachi drive. We recommend Firmware Toolbox to do the flashing, but other upcoming software tools would work fine, no special procedure to read / flash.